That distance is measured from the stabilizer block to the approximate shape of the main reactor. The idea is that a reactor needs to be stabilized beyond a certain value to function properly and that the stabilizer blocks have to be a sufficient enough distance away of the main reactor to be effective. The system we went for is a combination of two blocks: Our system should be working with as few special cases as possible. We went through a lot of iterations like restrictions compared to dimensions as well as mass, but all of these had major problems that would enable players to just circumvent the restrictions and fill a ship with systems regardless. The only way that this is possible, is if there isn’t a reason to fill up a ship with it. Our main goal was to make the power reactor components smaller, making sure that anything that uses power is also kept at a relatively small size. Ships will perform similar as before, yet power regeneration and consumption values were changed drastically and simply can’t be compared easily with the old power system. However, it can be difficult if you build ships with the old power system in mind and expect similar results. The new power system is relatively simple but has a lot of depth if you are going for optimal building. While we could have skipped this step, it would have probably cost more time after just adding new features, so we went for the option to fix the foundations first, and then add new stuff, as well as finish other incomplete features. A lot of foundation had to be made so that adding new stuff wouldn’t cause a problem in the end.
#STARMADE CREATIVE MODE COMMAND UPDATE#
Not only will that reduce bugs, it will also speed up the process of finding any remaining issues, as well as adding new features a lot faster, easier and streamlined.Ĭonsider this update as a way to prepare the game to enter a phase of rapid development.
#STARMADE CREATIVE MODE COMMAND CODE#
Additionally, a change of this system allowed for a massive code overhaul of some very fundamental systems. There is a lot more in this update than just the power system itself. Implementation based on partly outdated code Scaling of power versus the surface area of shipsįilling ships with power and systems is almost impossible to change afterwards without tearing it down completelyĪdditions of bigger features was hard on existing systemĬonsumption model was not consistent and didn’t scale well in terms of balance. The main motivation to update the power system comes from a few basic issues that the old power system has. Make sure to clean out your old power before adding the new power components to your ship. All structures will be counted as “new” power until you place down an old power block at which point they will convert to the old system.Īnything that still uses the old power blocks, will stay like that till the very last old power block is removed. If old power is allowed, the system will detect which version to use based on the structure’s root entity (mothership, station or planet) and check if that has any old power blocks. It’s advised to not switch from allowed to disallowed and back again constantly though. There is an option in the ServerConfig to completely disable the old power system should a server admin want that. They can be re-enabled in the block editor if needed (set inShop to true) or you can still access them through the admin command /give “player_name” “block_name” if you’re an admin or in single player. Old ships are still loadable and fully usable but the old power and its related blocks are disabled in shops, creative mode and factories. There is an all new power system in this build. We did change some features along the way to resolve the issues that were brought up and it might not be a bad idea to go through it once again. If you kept track with our last few dev blogs, you will already know how the majority of it works. The power update has been finally released.
0 kommentar(er)
